Kk2.jpg Page

: Plug your receiver outputs into the left side of the board. Follow the pin definitions for Aileron, Elevator, Throttle, and Rudder.

: To prepare the motors for flight, move the throttle to zero and the rudder stick to the far right . A red LED or an "Armed" message on the screen will appear. kk2.jpg

: Always remove your propellers before connecting a battery for the first time or performing calibrations to avoid accidental injury. 2. Initial Configuration : Plug your receiver outputs into the left side of the board

: Wait for the confirmation beep (idle signal) and release the buttons. 4. Arming and Flying A red LED or an "Armed" message on the screen will appear

: Use the on-board "PI Editor" to adjust the gain settings if your drone feels shaky or sluggish. Beginners can often start with the default firmware settings provided by DroneTrest. KK2.1 Flight Controller Guide - Guides

: Use the "Subtrim" function on your transmitter to ensure all values (except throttle) show ZERO when the sticks are centered. 3. ESC Calibration

: Hold down Buttons 1 and 4 on the KK2 board and keep them pressed. Power Up : Plug in the drone's battery.